YOUR ULTIMATE GUIDE ON ROOF LEAKS
A leaky roof is every homeowner’s worse nightmare. Roof leaks can be sneaky; there is no doubt about that. They can appear out of nowhere, and the hardest part is identifying them on time. In reality, roof leaks don’t have to be as awful as many articles represent them to be. Just like any other damage on the roof, leaks can be repaired and taken care of. To stop homeowners from worrying too much and overthinking, we’ve decided to create this ultimate guide on roof leaks. We’re going to cover everything from how to find roof leaks to how to repair them on your own.
HOW TO LOCATE THE SOURCE OF LEAKING
Finding the source of leaking isn’t always easy, and it can be the trickiest part of dealing with a leaky roof. The source often isn’t visible, so it’s hard to track it down.
VISIT THE ATTIC
You should start by going in the attic with a flashlight. The best time to inspect the attic is during a heavy rain. You can also ask someone to assist you by wetting the roof with a hosepipe.
Look closely at the roof decking in the attic just above the wet stain. Try to follow water stains or spots up to the roof decking to the highest point. Measure from the roof peak to the maximum point of leak you’ve just followed. Apply those measurements to the roof once it’s dry and look for any signs of the leak.
COMMON CAUSES OF ROOF LEAKS
If you’ve already been through the whole mess of finding and dealing with a leak, you should learn about the common causes, so it doesn’t repeat.
BROKEN OR MISSING SHINGLES
If you find random shingles in your yard, then the cause of leaking is evident. Heavy rainstorms, hail and high winds can damage or pull out your shingles. You should hop on the roof after each storm to check if any shingles are missing.
Flashing are strips of metal that seal the penetrations on your roof. They create a waterproof barrier, so if they open up or crack, water can quickly come in. Flashing are crucial, and they have to be often inspected.
Sometimes, your roof is simply too old, and it’s time to replace it. Over time, roofing material can deteriorate and weaken. Instead of constantly patching roof leaks, replace your old roof with brand new one.
Gutters are essential. Their primary purpose is to lead the water away from your roof. Sometimes, they can become clogged with leaves, branches or other debris. Over time, debris can stop the flow of water and cause a leak. According to Ranger Roofing of Oklahoma, a roof repair company from Tulsa, homeowners should try to clean their gutters as often as possible.
DIY ROOF LEAK REPAIR
It’s best to call a professional if there is a severe leak. However, sometimes you can handle small leaks on your own. Here are three ways how you can repair a leaky roof by yourself with some patience and equipment.
FIX A FLAT ROOF LEAK
To patch a leak on a flat roof, you will need to apply primer to the area and wait for it to dry. Cut the amount of patching material you need and imbricate onto the roof. Implement the patch you cut to the primed area and make sure it’s well sealed. Dust off any loose material from the damaged area. Apply primer to the area, overlapping it onto the whole part of the roof.
REPAIR ASPHALT SHINGLES
If the leaking source is a shingle, then you can replace it easily. Simply lift the damaged shingle and use a pry bar to pull the tab above the damage. Remove all the pins and slide a new shingle. Fasten it with roofing nails and coat them with adhesive.
FIX LEAKY FLASHING
Poorly installed flashing can always be problematic. Luckily, it’s easy to repair. You should remove any old sealant and use a screwdriver to push flashing clips into their place. Be sure to apply a lot of sealant along the entire joint.
Roof leaks can be quite messy, but with some patience, you can handle them easily. Learn as much as you can about the causes of roof damage and do your best to prevent it. Ranger Roofing of Oklahoma, your trustworthy roofing company from Tulsa, OK is here to help.